Precaution [11/2015 - 06/2017]

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTE:

When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected.

System Name
Lane Departure Alert System	Refer to INITIALIZATION [11/2015 - 06/2017]
Power Door Lock Control System
Pre-collision System

IGNITION SWITCH EXPRESSIONS

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this information.

Expression	Ignition Switch (Position)	Power Switch (Condition)
Ignition Switch off	LOCK	Off (Lock)
Ignition Switch ACC	ACC	On (ACC)
Ignition Switch ON (IG)	ON (IG)	On (IG)
Ignition switch ON (READY)	ON (READY)	On (Ready)

POWER WINDOW CONTROL SYSTEM PRECAUTIONS
WARNING:
- The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2015 - ] ). Troubleshoot the power window control system after confirming that the communication system is functioning properly.
- The power window control system prohibits the auto up and down function when the jam protection function malfunctions.
- If the power window regulator motor assembly has been replaced with a new one, initialize the power window control system.
- If the power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if the power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.
- After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operations at least 5 times:
  1. Close the power window by fully pulling up the power window regulator master switch assembly and holding it in the auto up position.
  2. Open the power window by fully pushing down the power window regulator master switch assembly.
- The jam protection function may operate unexpectedly even when the power window control system is normal due to detection of a value different from the operation learned value when the door glass moving speed changes sharply under any of the following conditions:
  1. A power window is being opened or closed while the vehicle is driven on a rough road.
  2. A power window is being opened or closed while the door is being opened or closed.
  3. The voltage changes abruptly.
NOTE:
Do not disconnect the auxiliary battery while the ignition switch is ON (IG). Otherwise, DTC B2313 will be stored.