Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated) [06/2017 - ]: Procedure

1. Initialize the power window regulator motor assembly LH (for driver door).

   Refer to INITIALIZATION [06/2017 - ]

   Result

   Proceed to
   NEXT

NEXT 

See step  2

1. Check that the driver door power window moves when the auto up and down functions of the power window regulator master switch assembly are operated.

   Refer to OPERATION CHECK [06/2017 - ]

   OK

   Driver door power window auto up and down functions are normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

See step  3

1. Remove the power window regulator motor assembly and door window regulator sub-assembly.
2. Install the door glass to the door glass run.
3. Check that the power window regulator motor assembly and door window regulator sub-assembly operate smoothly.
4. Check that the door glass slides smoothly when sliding it down by hand.
   NOTE:

   Make sure to perform initialization again.

   HINT: 

   Ensure the following: 

   • The door glass fits in the door glass run without improper contact or deformation.
   • Foreign matter is not caught in the door glass run.
   • The door glass run is not misaligned.
   • The door glass is not tilted and does not catch on the door glass run.

   OK

   Door glass slides smoothly.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR). Refer to  REMOVAL [11/2015 - ] 

Result: 

NG 

FIT DOOR GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE PARTS)