Jam Protection Function does not Operate [11/2015 - ]: Procedure
- PERFORM INITIALIZATION (DRIVER DOOR WINDOW MOTOR)
- Initialize the power window regulator motor assembly LH (for driver door) (Refer to INITIALIZATION [11/2015 - 06/2017] Refer to INITIALIZATION [06/2017 - ] ).
NEXT
See step 2
- CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (FOR DRIVER DOOR))
- Check if the power window auto up and down function operate normally (Refer to OPERATION CHECK [11/2015 - 06/2017]
Refer to OPERATION CHECK [06/2017 - ]
).
OK
Driver door auto up and down function is normal.
Result:
NG
REFER TO OTHER PROBLEM (Proceed to Problem Symptoms Table)
Refer to PROBLEM SYMPTOMS TABLE [11/2015 - 06/2017] Refer to PROBLEM SYMPTOMS TABLE [06/2017 - ] )
Result:
OK
See step 3
- Check if the power window auto up and down function operate normally (Refer to OPERATION CHECK [11/2015 - 06/2017]
Refer to OPERATION CHECK [06/2017 - ]
).
- CHECK JAM PROTECTION FUNCTION OPERATING RANGE
- Check if the jam protection function operates normally for the driver door power window.
HINT:
The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.
OK
Jam protection function operates normally.
Result:
OK
END (PROBLEM DUE TO INITIALIZATION FAILURE)
Result:
NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR)
Refer to REMOVAL [11/2015 - ] )
- Check if the jam protection function operates normally for the driver door power window.