DTC P062F: Internal Control Module EEPROM Error [11/2015 - ]: Procedure
- READ OUTPUT DTC (DTC P062F)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON (IG).
- Turn the Techstream on.
- Clear the DTCs (Refer to DTC CHECK / CLEAR [11/2015 - ] ).
- Turn the ignition switch off and turn the Techstream off.
- Disconnect the Techstream.
- Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) auxiliary battery terminal.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON (IG).
- Turn the Techstream on.
- Put the engine in inspection mode (maintenance mode) (Refer to INSPECTION MODE PROCEDURE [11/2015 - ] ).
- Start the engine and wait 30 seconds or more.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.RESULT
Result Proceed to DTCs are not output A DTC P062F is output B
Result:
A
CHECK FOR INTERMITTENT PROBLEMS
Refer to CHECK FOR INTERMITTENT PROBLEMS [11/2015 - ] )
Result:
B
REPLACE ECM
Refer to REMOVAL [11/2015 - ] )