Navigation Receiver Assembly Power Source Circuit [11/2015 - ]: Procedure

1. Disconnect the F93 and F92 navigation receiver assembly connectors.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F93-7 (GND1) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F93-4 (+B1) - F93-7 (GND1)	Power switch off	11 to 14 V
   F93-3 (ACC1) - F93-7 (GND1)	Power switch on (ACC)	11 to 14 V
   F92-1 (IG) - F93-7 (GND1)	Power switch on (IG)	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [11/2015 - 11/2017]  , or refer to  PROBLEM SYMPTOMS TABLE [11/2017 - 08/2019]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2019 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR