Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated) [08/2015 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location). Refer to INITIALIZATION [08/2015 - ] .

NEXT: Go to next step 

1. Check that each front power window moves when the auto up and down functions of the power window regulator master switch assembly or power window regulator switch assembly are operated. Refer to OPERATION CHECK [08/2015 - ] .

   OK

   Auto up and down functions are normal (applicable location).

NG → Refer to   3 

OK → END (PROBLEM DUE TO INITIALIZATION FAILURE) 

1. Remove the power window regulator motor assembly and door window regulator sub-assembly.
2. Install the door glass to the door glass run.
3. Check if the power window regulator motor assembly and door window regulator sub-assembly operate smoothly.
4. Check that the door glass slides smoothly when sliding it down by hand.
   NOTE:

   Make sure to perform initialization. Refer to INITIALIZATION [08/2015 - ] .

   HINT: 

   Ensure the following:

   • The door glass fits in the door glass run without improper contact or deformation.
   • Foreign matter is not caught in the door glass run.
   • The door glass run is not misaligned.
   • The belt moulding or inner weatherstrip is not caught.
   • The door glass is not tilted and does not catch.

   OK

   Door glass slides smoothly.

   RESULT
   
   

   Result	Proceed to
   NG	A
   OK (Driver door power window)	B
   OK (Front Passenger door power window)	B
   OK (Rear LH door power window)	C
   OK (Rear RH door power window)	C

B → Refer to   4 

C → Refer to   5 

A → FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE)