DTC C1A4B: Stop Light Relay Circuit [08/2015 - ]: Description
The brake booster with master cylinder (skid control ECU) sends a stop light operation signal to the stop light switch assembly. When the brake booster with master cylinder (skid control ECU) detects a malfunction in the stop light circuit, the driving support ECU assembly stores DTC C1A4B.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1A4B |
Either of the following conditions is met:
- When the vehicle speed is approximately 50 km/h or more, the cruise control switch (ON-OFF button) is on, the IG1 terminal voltage is between 11 and 14 V and the stop light illumination output signal (STPO) is output, the signal is not received at terminal STP2 for 0.3 seconds or more.
- When the vehicle speed is approximately 50 km/h or more, the cruise control switch (ON-OFF button) is on, the IG1 terminal voltage is between 11 and 14 V and the stop light illumination output signal (STPO) is not output, the signals received at terminals STP and STP2 are different for 0.3 seconds or more.
|
- Lighting system
- Electronically controlled brake system
- Harness or connector
- Stop light switch assembly
- Driving support ECU assembly
|