DTC C1A10: Front Radar Sensor [08/2015 - ]: Procedure

REPLACE MILLIMETER WAVE RADAR SENSOR
1. Replace the millimeter wave radar sensor. Refer to REMOVAL [08/2015 - ] .
NEXT: Go to next step
ADJUST MILLIMETER WAVE RADAR SENSOR
1. Adjust the millimeter wave radar sensor. Refer to ADJUSTMENT [08/2015 - ] .
NEXT: Go to next step
CHECK DTC OUTPUT (PRE-COLLISION SYSTEM)
1. Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
2. Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ] .
3. Recheck for DTCs.
  OK
  
  DTC C1A10 is not output.
NG → Refer to 4

OK → END (MILLIMETER WAVE RADAR SENSOR WAS DEFECTIVE)
REPLACE DRIVING SUPPORT ECU ASSEMBLY. Refer to REMOVAL [08/2015 - ]