Engine does not Start [08/2016 - 08/2017]: Description

When the key is in the vehicle and the engine switch is pressed, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. In addition, when the shift lever is in P or N and the brake pedal is depressed, the engine can be started by pressing the engine switch.

HINT:

When the certification ECU (smart key ECU assembly) is replaced with a new one and the cable is connected to the negative (-) battery terminal, the power source mode changes to on (IG).
When the battery cable is disconnected and reconnected, the power source returns to the mode it was in before the battery cable was disconnected.

RELATED DATA LIST AND ACTIVE TEST ITEMS

Problem Symptom	Data List Item	Active Test Item
Engine does not start	Power Source Control: Stop Light Switch1 Steering Unlock Switch Power Supply Condition IG1 Relay Monitor(Inside) IG2 Relay Monitor(Inside) IG1 Relay Monitor(Outside) IG2 Relay Monitor(Outside) Latch Circuit Shift P Signal Neutral SW/ Clutch SW Starter Request Signal Smart Key: Immobiliser L Code Check Engine Start Request Starting Control: Ignition Starter SW Shift Position P or N	-

Problem Symptom

Data List Item

Active Test Item

Engine does not start

Power Source Control:

Stop Light Switch1
Steering Unlock Switch
Power Supply Condition
IG1 Relay Monitor(Inside)
IG2 Relay Monitor(Inside)
IG1 Relay Monitor(Outside)
IG2 Relay Monitor(Outside)
Latch Circuit
Shift P Signal
Neutral SW/ Clutch SW
Starter Request Signal

Smart Key:

Immobiliser
L Code Check
Engine Start Request

Starting Control:

Ignition
Starter SW
Shift Position P or N