Caution / Notice / Hint

NOTE:

Inspect the fuses for circuits related to this system before performing the following procedure.
When replacing or inspecting the door control receiver and wire harness, do not change the position or length of the wire harness. If the wire harness is too close to the door control receiver, wireless function performance may be affected.
Refer to REGISTRATION [12/2012 - ]
When replacing the door control receiver, read the transmitter IDs (tire pressure warning system) stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform initialization after registration of the transmitter IDs into the door control receiver if the door control receiver has been replaced.
for Initialization:

Refer to INITIALIZATION [12/2012 - ]

for Registration:

Refer to REGISTRATION [12/2012 - ]
for 12 Pin Type:
First, confirm that there are no malfunctions in the tire pressure warning system. Refer to the How to Proceed with Troubleshooting procedure.

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2012 - ]
When replacing the main body ECU (multiplex network body ECU), make sure to replace it with a new one.