DTC C1AC1: Master Module Horizontal Axis Misalignment [12/2012 - 10/2015]: Procedure

1. Check the installation condition of the blind spot monitor sensor LH.

   Refer to OPERATION CHECK [12/2012 - 10/2015] .

   HINT: 

   Take the appropriate action in accordance with the result.

Result: 

NEXT 

See step  2

1. Install the rear bumper.

   Refer to INSTALLATION [12/2012 - 10/2015] .

2. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream.

   Refer to OPERATION CHECK [12/2012 - 10/2015] .

   Result	Proceed to
   	OK
   	NG

Result: 

OK 

END 

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR LH. Refer to  REMOVAL [12/2012 - 10/2015]