How To Proceed With Troubleshooting [12/2015 - 11/2017]: Procedure

Result

Result: 

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2015 - 08/2016] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017] )

Result: 

A 

See step  4

Refer to DTC Check / Clear (Refer to DTC CHECK / CLEAR [12/2015 - 08/2016] , or refer to DTC CHECK / CLEAR [08/2016 - 11/2017] ).

1. Check for DTCs and note any codes that are output.
2. Clear the DTCs.
3. Recheck for DTCs. Try to prompt the DTCs by duplicating the conditions indicated by the DTCs.

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO DTC CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2015 - 08/2016] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2016 - 11/2017] )

Result: 

A 

See step  5

Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [12/2015 - 08/2016] , or refer to PROBLEM SYMPTOMS TABLE [08/2016 - 11/2017] ).

Result

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Terminals of ECU (Refer to TERMINALS OF ECU [12/2015 - 08/2016] , or refer to TERMINALS OF ECU [08/2016 - 11/2017] ).
2. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [12/2015 - 08/2016] , or refer to DATA LIST / ACTIVE TEST [08/2016 - 11/2017] ).

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END