Power Source Mode does not Change to ON (ACC) [12/2015 - ]: Procedure

See step  1, or see step  1

Result: 

NG 

GO TO DTC CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2015 - 08/2016] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2016 - ] )

Result: 

OK 

See step  2

See step  3

Result: 

NG 

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY 

Result: 

OK 

See step  3

See step  4

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

See step  5

Result: 

NG 

REPLACE POWER MANAGEMENT CONTROL ECU 

(Refer to REMOVAL [12/2015 - 11/2017] , or refer to REMOVAL [11/2017 - ] )

Result: 

OK 

See step  5

See step  8, or see step  8

Result: 

OK 

SYSTEM RETURNED TO NORMAL (PROBLEM OCCURRED DUE TO BAD CONNECTION, BUT RETURNED TO NORMAL BY RECONNECTING CONNECTOR) 

Result: 

NG 

CHECK RELAY CONTACT CIRCUIT