DTC B2313: Glass Position Initialization Incomplete [12/2015 - ]: Procedure

1. Turn the ignition switch to ON.
2. Initialize the power window regulator motor assembly (Refer to INITIALIZATION [12/2015 - ] ).

   HINT: 

   Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.

Result: 

NEXT 

See step  2

1. Turn the ignition switch off.
2. Wait for at least 10 seconds, and then turn the ignition switch to ON.
3. Check for DTCs (Refer to DTC CHECK / CLEAR [12/2015 - ] ).

   HINT: 

   Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.

   OK

   B2313 output does not recur.

   RESULT
   
   

   Result	Proceed to
   OK	A
   NG (Driver side power window)	B
   NG (Front passenger side power window)	C
   NG (Rear LH side power window)	D
   NG (Rear RH side power window)	E

Result: 

A 

END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED) 

Result: 

B 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

(Refer to REMOVAL [12/2015 - ] )

Result: 

C 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

(Refer to REMOVAL [12/2015 - ] )

Result: 

D 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

(Refer to REMOVAL [12/2015 - ] )

Result: 

E 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

(Refer to REMOVAL [12/2015 - ] )