Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) [12/2015 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location) (Refer to INITIALIZATION [12/2015 - ] ).

Result: 

NEXT 

See step  2

1. Check that all door power windows move when the auto up/down function of the multiplex network master switch assembly and power window regulator switch assembly (for front passenger, rear LH and rear RH sides) is operated (Refer to OPERATION CHECK [12/2015 - ] ).

   OK

   Auto up/down function is normal (applicable location).

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

See step  3

1. Remove the window regulator.
2. Install the window glass onto the door glass run.
3. Check if the door window regulator operates smoothly.
4. Check that the window glass slides smoothly when sliding it up by hand.

   OK

   Door window glass slides smoothly.

   WARNING:

   Perform initialization again.

   HINT: 

   Ensure the following: 

   • The window glass fits with the glass run without improper contact or deformation.
   • Foreign matter is not caught in the glass run.
   • The glass run is not misaligned.
   • The belt moulding or inner weatherstrip is not caught.
   • The glass is not tilted and does not catch.
   RESULT
   
   

   Result	Proceed to
   NG	A
   OK (Driver side power window)	B
   OK (Front passenger side power window)	C
   OK (Rear LH side power window)	D
   OK (Rear RH side power window)	E

Result: 

A 

FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN OBJECTS CAUSING IMPROPER FIT OR REPLACE PARTS) 

Result: 

B 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

(Refer to REMOVAL [12/2015 - ] )

Result: 

C 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

(Refer to REMOVAL [12/2015 - ] )

Result: 

D 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

(Refer to REMOVAL [12/2015 - ] )

Result: 

E 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

(Refer to REMOVAL [12/2015 - ] )