Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [12/2015 - ]: Procedure
- READ VALUE USING TECHSTREAM (MASTER SWITCH)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Master switch / Data List.
- Read the Data List according to the display on the Techstream.MASTER SWITCH (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note D Door P/W Auto SW Driver side power window auto up/down switch signal / ON or OFF ON: Driver side power window auto switch operated
OFF: Driver side power window auto switch not operated- OK
On the Techstream screen, ON or OFF is displayed accordingly.
Result:
NG
REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(Refer to REMOVAL [12/2015 - ] )
Result:
OK
See step 2
- READ VALUE USING TECHSTREAM (D-DOOR MOTOR)
- Enter the following menus: Body Electrical / D-Door Motor / Data List.
- Read the Data List according to the display on the Techstream.D-DOOR MOTOR (FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note D Door P/W Auto SW Driver side power window auto up/down switch signal / ON or OFF ON: Driver side power window auto switch operated
OFF: Driver side power window auto switch not operated- OK
On the Techstream screen, ON or OFF is displayed accordingly.
Result:
NG
See step 5
Result:
OK
See step 3
- PERFORM INITIALIZATION (for Driver Side)
- Initialize the front power window regulator motor assembly LH (Refer to INITIALIZATION [12/2015 - ] ).
Result:
NEXT
See step 4
- CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
- Check that the driver side door power window moves when the auto up/down function of the multiplex network master switch assembly is operated (Refer to OPERATION CHECK [12/2015 - ]
).
OK
Driver side auto up/down function is normal.
Result:
OK
END (PROBLEM DUE TO INITIALIZATION FAILURE)
Result:
NG
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
(Refer to REMOVAL [12/2015 - ] )
- Check that the driver side door power window moves when the auto up/down function of the multiplex network master switch assembly is operated (Refer to OPERATION CHECK [12/2015 - ]
).
- REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
- Replace the multiplex network master switch assembly (Refer to REMOVAL [12/2015 - ] ).
Result:
NEXT
See step 6
- CHECK AND REPLACE POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
- Check that the driver side door power window moves when the auto up/down function of the multiplex network master switch assembly is operated (Refer to OPERATION CHECK [12/2015 - ]
).
OK
Driver side auto up/down function is normal.
Result:
OK
END (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WAS DEFECTIVE)
Result:
NG
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
(Refer to REMOVAL [12/2015 - ] )
- Check that the driver side door power window moves when the auto up/down function of the multiplex network master switch assembly is operated (Refer to OPERATION CHECK [12/2015 - ]
).