Jam Protection Function does not Operate [12/2015 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location) (Refer to INITIALIZATION [12/2015 - ] ).

Result: 

NEXT 

See step  2

1. Check if the power window auto up/down function operates normally (Refer to OPERATION CHECK [12/2015 - ] ).

   OK

   Auto up/down function is normal.

Result: 

NG 

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) 

(Refer to PROBLEM SYMPTOMS TABLE [12/2015 - ] )

Result: 

OK 

See step  3

1. Check if the jam protection function operates normally for the applicable power window.

   HINT: 

   The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

   OK

   Jam protection function operates normally.

   RESULT
   
   

   Result	Proceed to
   OK	A
   NG (Driver side power window)	B
   NG (Front passenger side power window)	C
   NG (Rear LH side power window)	D
   NG (Rear RH side power window)	E

Result: 

A 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

B 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

(Refer to REMOVAL [12/2015 - ] )

Result: 

C 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

(Refer to REMOVAL [12/2015 - ] )

Result: 

D 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

(Refer to REMOVAL [12/2015 - ] )

Result: 

E 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

(Refer to REMOVAL [12/2015 - ] )