DTC B1785: Front Occupant Classification Sensor LH Collision Detection [12/2015 - ]: Procedure
- PERFORM ZERO POINT CALIBRATION
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON, and wait for at least 60 seconds.
- Using the Techstream, perform the zero point calibration (Refer to INITIALIZATION [12/2015 - ] ).
Result:
NG
See step 3
Result:
OK
See step 2
- CHECK FOR DTC
- Turn the ignition switch to ON, and wait for at least 60 seconds.
- Clear any DTCs stored in the memory (Refer to DTC CHECK / CLEAR [12/2015 - ]
).
HINT:
- First clear DTCs stored in the occupant classification ECU and then in the center airbag sensor assembly.
- Use the Techstream to clear the DTCs of the occupant classification ECU, otherwise the DTCs cannot be cleared.
- Turn the ignition switch off.
- Turn the ignition switch to ON, and wait for at least 60 seconds.
- Using the Techstream, check for DTCs of the occupant classification ECU (Refer to DTC CHECK / CLEAR [12/2015 - ]
).
OK
DTC B1785 is not output.
HINT:
DTCs other than DTC B1785 may be output at this time, but they are not related to this check.
RESULTResult Proceed to NG A OK B
Result:
B
See step 5
Result:
A
See step 3
- REPLACE FRONT SEAT CUSHION SPRING ASSEMBLY RH
- Turn the ignition switch off.
- Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
- Replace the front seat cushion spring assembly RH.
- for Manual seat (Refer to REMOVAL [12/2015 - ] ).
- for Power seat (Refer to REMOVAL [12/2015 - ] ).
HINT:
Perform the inspection using parts from a normal vehicle when possible.
Result:
NEXT
See step 4
- PERFORM ZERO POINT CALIBRATION
- Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON, and wait for at least 60 seconds.
- Using the Techstream, perform the zero point calibration (Refer to INITIALIZATION [12/2015 - ] ).
Result:
NEXT
See step 5
- PERFORM SENSITIVITY CHECK
- Using the Techstream, perform the sensitivity check (Refer to INITIALIZATION [12/2015 - ]
).
Standard range
27 to 33 kg (59.5 to 72.8 lb)
Result:
NEXT
END
- Using the Techstream, perform the sensitivity check (Refer to INITIALIZATION [12/2015 - ]
).