DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [08/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.
5. Turn the ignition switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
8. Connect the cable to the negative (-) battery terminal.
9. Connect the Techstream to the DLC3.
10. Turn the ignition switch to ON.
11. Turn the Techstream on.
12. Start the engine and wait 30 seconds or more.
13. Enter the following menus: Powertrain / Transmission / Trouble Codes.
14. Read the DTCs.

    Result

    Result	Proceed to
    DTCs are not output	A
    DTC P062F-44 is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [08/2016 - ] 

Result: 

B 

See step  2

1. Replace the ECM.

   Refer to COMPONENTS [08/2016 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM A/T CODE REGISTRATION. Refer to  REGISTRATION [08/2016 - ]