How To Proceed With Troubleshooting [12/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

Result: 

A 

See step  4

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [12/2015 - 11/2017] Refer to DTC CHECK / CLEAR [11/2017 - ] 

2. Clear the DTCs.
3. Recheck for DTCs.

   Result

   Result	Proceed to
   DTC does not reoccur	A
   DTC does reoccur	B

Result: 

B 

See step  7

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table.

   Result

   Result	Proceed to
   Fault not listed in problem symptoms table	A
   Fault listed in problem symptoms table	B

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Terminals of ECU.

   Refer to TERMINALS OF ECU [12/2015 - ] 

2. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [12/2015 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END