How To Proceed With Troubleshooting [12/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   (Refer to DIAGNOSIS SYSTEM [12/2015 - 08/2016] Refer to DIAGNOSIS SYSTEM [08/2016 - 11/2017] Refer to DIAGNOSIS SYSTEM [11/2017 - 08/2018] Refer to DIAGNOSIS SYSTEM [08/2018 - ] ).

   Result

   Result	Proceed to
   CAN DTCs are not output	A
   CAN DTCs are output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2015 - 08/2016] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - ] )

Result: 

A 

See step  4

1. Check for DTCs.

   (Refer to DTC CHECK / CLEAR [12/2015 - ] ).

2. Clear the DTCs.

   (Refer to DTC CHECK / CLEAR [12/2015 - ] ).

3. Recheck for DTCs.

   (Refer to DTC CHECK / CLEAR [12/2015 - ] ).

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2015 - ] )

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table.

   (Refer to PROBLEM SYMPTOMS TABLE [12/2015 - 08/2016] Refer to PROBLEM SYMPTOMS TABLE [08/2016 - ] ).

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Operation Check

   (Refer to OPERATION CHECK [12/2015 - ] )

2. Data List / Active Test

   (Refer to DATA LIST / ACTIVE TEST [12/2015 - ] )

3. Terminals of ECU

   (Refer to TERMINALS OF ECU [12/2015 - ] )

4. Inspection

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END