Installation [08/2015 - 11/2017]: Procedure
- INSTALL FRONT SPEED SENSOR
- Install the front speed sensor with the bolt.
Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
NOTE:Make sure that the sensor tip is clean.
- Connect the speed sensor connector.
- Install the front speed sensor with the bolt.
- INSTALL FRONT WHEEL
Torque: 113 N*m (1152 kgf*cm, 83 ft.*lbf)
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- CHECK VSC SENSOR SIGNAL (for Hydraulic Brake Booster)
(Refer to TEST MODE PROCEDURE [08/2015 - 11/2017] )
- CHECK VSC SENSOR SIGNAL (for Vacuum Brake Booster)
(Refer to TEST MODE PROCEDURE [08/2015 - 11/2017] )