Installation [08/2015 - ]: Procedure

1. Apply a light coat of power steering fluid to the O-ring of the power steering oil pressure switch.
   NOTE:

   When reusing the power steering oil pressure switch, inspect the O-ring.

2. Using a 19 mm deep socket wrench, install the power steering oil pressure switch.

   Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

   NOTE:

   • Do not allow foreign matter to contact the O-ring face of the power steering oil pressure switch (surface which contacts the pressure feed tube assembly).
   • Be careful not to damage the O-ring when installing the power steering oil pressure switch.
3. Connect the connector to the power steering oil pressure switch.

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 50 [08/2015 - 11/2017] , or refer to PROCEDURE - Step 50 [11/2017 - ]