DTC P060B: Internal Control Module A/D Processing Performance [07/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTC (Refer to DTC CHECK / CLEAR [07/2015 - ] ).
5. Turn the ignition switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
8. Connect the cable to the negative (-) battery terminal.
9. Connect the Techstream to the DLC3.
10. Turn the ignition switch to ON.
11. Turn the Techstream on.
12. Wait 16 seconds or more.
13. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
14. Read DTCs.

    Result	Proceed to
    DTC is not output	A
    DTC P060B is output	B
    DTC P060B and P0327, P0328 are output	C

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS 

(Refer to CHECK FOR INTERMITTENT PROBLEMS [07/2015 - ] )

Result: 

B 

REPLACE ECM 

(Refer to REMOVAL [07/2015 - ] )

Result: 

C 

GO TO DTC P0327, P0328 

(Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor) ; DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor) [07/2015 - ] )