Engine Coolant Temperature Sensor: Inspection: Procedure
- INSPECT ENGINE COOLANT TEMPERATURE SENSOR
- Resistance Inspection
- Disconnect the negative battery cable.
Refer to REMOVAL
- Drain the engine coolant.
Refer to REPLACEMENT
- Remove the ECT sensor No. 1.
Refer to REMOVAL
- Place the ECT sensor No. 1 in water with a thermometer, and heat the water gradually.
*a ECT Sensor No. 1 *a Resistance (Kilohms) *b ECT (°C (°F)) - Measure the resistance between ECT sensor No. 1 terminals 1 and 2.
If not as specified, replace the ECT sensor No. 1.
Refer to REMOVAL
SPECIFICATION (REFERENCE)ECT (°C (°F)) Resistance (Kilohms) 20 (68) Approx. 2.45 80 (176) Approx. 0.318
- Disconnect the negative battery cable.
- Resistance Inspection
- INSPECT ENGINE COOLANT TEMPERATURE SENSOR NO. 2
- Resistance Inspection
- Disconnect the negative battery cable.
Refer to REMOVAL
- Drain the engine coolant.
Refer to REPLACEMENT
- Remove the ECT sensor No. 2.
Refer to REMOVAL
- Place the ECT sensor No. 2 in water with a thermometer, and heat the water gradually.
*a ECT Sensor No. 2 *a Resistance (Kilohms) *b ECT (°C (°F)) - Measure the resistance between ECT sensor No. 2 terminals 1 and 2.
If not as specified, replace the ECT sensor No. 2.
Refer to REMOVAL
SPECIFICATION (REFERENCE)ECT (°C (°F)) Resistance (Kilohms) 20 (68) Approx. 2.45 80 (176) Approx. 0.318
- Disconnect the negative battery cable.
- Resistance Inspection