How To Proceed With Troubleshooting [08/2015 - 08/2019]: Procedure
- VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to NEXT Result:
NEXT
See step 2
- INSPECT BATTERY VOLTAGE
Standard voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
Result
Proceed to NEXT Result:
NEXT
See step 3
- CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
- Use the Techstream to check if the CAN communication system is functioning normally.
Result
Result Proceed to CAN DTC is not output A CAN DTC is output B
Result:
B
GO TO CAN COMMUNICATION SYSTEM
(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )
Result:
A
See step 4
- Use the Techstream to check if the CAN communication system is functioning normally.
- CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
- Use the Techstream to check if the LIN communication system is functioning normally.
Result
Result Proceed to LIN DTC is not output A LIN DTC is output B
Result:
B
GO TO LIN COMMUNICATION SYSTEM
(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )
Result:
A
See step 5
- Use the Techstream to check if the LIN communication system is functioning normally.
- CHECK FOR DTC*
- Check for DTCs. Based on the DTCs output, try to cause the same steering lock system DTC, engine immobiliser system DTC or smart key system (for Entry Function) DTC to be stored by reproducing the symptoms indicated by the DTC.
Result
Result Proceed to DTC is not output A Steering lock system DTC is output B Engine immobiliser system DTC is output C Smart key system (for Entry Function) DTC is output D
Result:
B
GO TO STEERING LOCK SYSTEM
(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )
Result:
C
GO TO ENGINE IMMOBILISER SYSTEM
(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )
Result:
D
GO TO DIAGNOSTIC TROUBLE CODE CHART
(Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019] )
Result:
A
See step 6
- Check for DTCs. Based on the DTCs output, try to cause the same steering lock system DTC, engine immobiliser system DTC or smart key system (for Entry Function) DTC to be stored by reproducing the symptoms indicated by the DTC.
- PROBLEM SYMPTOMS TABLE
- Refer to the Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019]
).
Result
Result Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B
Result:
B
See step 8
Result:
A
See step 7
- Refer to the Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019]
).
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Operation Check (Refer to OPERATION CHECK [08/2015 - 08/2019] ).
- Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2019] ).
- Terminals of ECU (Refer to TERMINALS OF ECU [08/2015 - 08/2019]
).
Result
Proceed to NEXT
Result:
NEXT
See step 8
- REPAIR OR REPLACEMENT
Result
Proceed to NEXT Result:
NEXT
See step 9
- CONFIRMATION TEST
Result
Proceed to NEXT Result:
NEXT
END