Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter [05/2019 - ]: Procedure

1. Disconnect the I95 navigation receiver assembly connector.
2. Disconnect the I116 No. 1 stereo jack adapter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Navigation Receiver Assembly)
   *b	Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly)

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I116-9 (UDO-) - I95-2 (US1-)	Always	Below 1 Ω
   I116-10 (UDO+) - I95-3 (US1+)	Always	Below 1 Ω
   I116-12 (USG1) - I95-5 (USG1)	Always	Below 1 Ω
   I116-9 (UDO-) or I95-2 (US1-) - Body ground	Always	10 kΩ or higher
   I116-10 (UDO+) or I95-3 (US1+) - Body ground	Always	10 kΩ or higher
   I116-12 (USG1) or I95-5 (USG1) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [05/2019 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR