Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier [09/2016 - 05/2019]: Procedure

1. Measure the voltage according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component with harness connected (Stereo Component Amplifier Assembly)

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   I64-1 (MUTE) - Body ground	Power switch on (ACC) Audio system playing → Audio system changing modes	2.0 V or higher → Below 1 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [09/2016 - 05/2019] 

Result: 

NG 

See step  2

1. Disconnect the I33 navigation receiver assembly connector.
2. Disconnect the I64 stereo component amplifier assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I33-16 (MUT1) - I64-1 (MUTE)	Always	Below 1 Ω
   I33-16 (MUT1) or I64-1 (MUTE) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Disconnect the I33 navigation receiver assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Navigation Receiver Assembly)

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   I33-16 (MUT1) - Body ground	Power switch on (ACC) Audio system playing	2.0 V or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE NAVIGATION RECEIVER ASSEMBLY. Refer to  REMOVAL [09/2016 - 05/2019] 

Result: 

NG 

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY. Refer to  REMOVAL [09/2016 - 05/2019]