Installation [08/2015 - ]: Procedure

1. Install a new O-ring to the oil pressure switch.
2. Apply a light coat of engine oil to the O-ring of the oil pressure switch.
3. Using a 24 mm deep socket wrench, install the oil pressure switch.

   Torque: 21 N.m (210 kgf/cm, 15 ft.lbf) 

   NOTE:

   • Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (surface which contacts the pressure feed tube).
   • Be careful not to damage the O-ring when installing the power steering oil pressure switch
4. Connect the oil pressure switch connector.

Refer to PROCEDURE - Step 2