How To Proceed With Troubleshooting [06/2016 - ]: Procedure
- VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to NEXT Result:
NEXT
See step 2
- INSPECT BATTERY VOLTAGE
- Check the battery voltage.
Standard Voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Check the battery voltage.
- CHECK FOR DTC*
- Check for DTCs and note any codes that are output.
Refer to DTC CHECK / CLEAR [06/2016 - ]
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [06/2016 - ]
- Recheck for DTCs.
Result
Result Proceed to DTC is not output A DTC is output B
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [06/2016 - ]
Result:
A
See step 4
- Check for DTCs and note any codes that are output.
- PROBLEM SYMPTOMS TABLE
Result
Result Proceed to Fault is not listed in Problem Symptoms Table A Fault is listed in Problem Symptoms Table B Result:
B
See step 6
Result:
A
See step 5
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Terminals of ECU.
Refer to TERMINALS OF ECU [06/2016 - ]
- Data List/Active Test.
Refer to DATA LIST / ACTIVE TEST [06/2016 - ]
- Operation check.
Refer to OPERATION CHECK [06/2016 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 6
- Terminals of ECU.
- REPAIR OR REPLACE
HINT:
Register the recognition code when replacing the door control transmitter or the door control receiver.
Result
Proceed to NEXT Result:
NEXT
See step 7
- CONFIRMATION TEST
Result
Proceed to NEXT Result:
NEXT
END