LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2019 >> 86 Base, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System - Diagnostic Codes (1 Of 6) >> SFI System >> DTC P0068: MAP / MAF - Throttle Position Correlation [06/2016 - 12/2017] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0068: MAP / MAF - Throttle Position Correlation [06/2016 - 12/2017]: Procedure

  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0068) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Trouble Codes.
    5. Read DTCs.
      RESULT

      Result Proceed to
      DTC P0068 is output A
      DTC P0068 and other DTCs are output B

    Result: 

    GO TO DTC CHART 

    (Refer to DIAGNOSTIC TROUBLE CODE CHART [06/2016 - 03/2017] , or refer to DIAGNOSTIC TROUBLE CODE CHART [03/2017 - 07/2018] )

    Result: 

    See step  2

  2. CHECK INTAKE SYSTEM 
    1. Check the intake system for vacuum leaks (Refer to ON-VEHICLE INSPECTION [06/2016 - ] ).

      OK

      PCV valve and hose are connected correctly and are not damaged.

    Result: 

    NG 

    REPAIR OR REPLACE INTAKE SYSTEM 

    Result: 

    OK 

    See step  3

  3. CHECK PCV HOSE CONNECTIONS 
    1. Check the PCV hose connections (Refer to ON-VEHICLE INSPECTION [06/2016 - ] ).

      OK

      No leaks from intake system.

    Result: 

    NG 

    REPAIR OR REPLACE PCV HOSE 

    Result: 

    OK 

    See step  4

  4. REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR 
    1. Replace the manifold absolute pressure sensor (Refer to REMOVAL [06/2016 - ] ).

    Result: 

    NEXT 

    See step  5

  5. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Clear the DTCs (Refer to DTC CHECK / CLEAR [06/2016 - ] ).
    5. Turn the ignition switch off and wait for at least 30 seconds.
    6. Turn the ignition switch to ON.
    7. Turn the Techstream on.
    8. Start the engine and warm it up.
    9. Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
    10. Enter the following menus: Powertrain / Engine / Utility / All Readiness.
    11. Input the DTC: P0068.
    12. Check the DTC judgment.

      Result

      Techstream Display Description
      NORMAL
      • DTC judgment completed
      • System normal
      ABNORMAL
      • DTC judgment completed
      • System abnormal
      INCOMPLETE
      • DTC judgment not completed
      • Perform driving pattern after confirming DTC enabling conditions
      N/A
      • Unable to perform DTC judgment
      • Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit

    Result: 

    NEXT 

    END