Installation [03/2017 - ]: Procedure

INSTALL STEERING SENSOR
1. Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.
  NOTE:
  Do not rotate the spiral cable until the steering sensor has been attached to it.
ALIGN FRONT WHEELS TO FACING STRAIGHT AHEAD
INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
INSTALL UPPER STEERING COLUMN COVER
Refer to PROCEDURE - Step 5
INSTALL LOWER STEERING COLUMN COVER
Refer to PROCEDURE - Step 6
INSTALL STEERING COLUMN COVER SUPPORT (w/ Smart Key System)
Refer to PROCEDURE - Step 7
INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 12
INSTALL UPPER INSTRUMENT PANEL METER ORNAMENT
Refer to PROCEDURE - Step 5
INSTALL METER HOOD SUB-ASSEMBLY
Refer to PROCEDURE - Step 6
INSTALL INSTRUMENT PANEL ORNAMENT
Refer to PROCEDURE - Step 15
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 8
INSTALL STEERING WHEEL ASSEMBLY
Refer to INSTALLATION [06/2016 - ]
INSPECT SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM [06/2016 - ]
PERFORM VSC SENSOR NEUTRAL MEMORIZATION
Refer to CALIBRATION [06/2016 - ]