Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [06/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Master Switch / Active Test.
5. Perform the Active Test according to the display on the Techstream.
   MASTER SWITCH
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   D Door P/W Auto SW	Driver side power window auto switch signal / ON or OFF	ON: Driver side power window auto up/down switch operated OFF: Driver side power window switch not operated	-

   OK

   The Techstream display changes normally when master switch is operated.

Result: 

NG 

See step  3

Result: 

OK 

See step  2

1. Initialize the power window regulator motor assembly (Refer to INITIALIZATION [06/2016 - ] ).
2. Check that the driver side door power window moves when the auto up and down function of the power window master switch assembly is operated (Refer to OPERATION CHECK [06/2016 - ] ).

   OK

   Driver side auto up and down function is normal.

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY 

(Refer to REMOVAL [06/2016 - ] )

1. Temporarily replace the power window regulator master switch assembly with a new or normally functioning one (Refer to REMOVAL [06/2016 - ] ).
2. Check the power window regulator master switch assembly operates (Refer to OPERATION CHECK [06/2016 - ] ).

   OK

   Driver door power window operates normally.

   RESULT
   
   

   Result	Proceed to
   Operate	A
   Does not operate	B

Result: 

A 

END (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WAS DEFECTIVE) 

Result: 

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY 

(Refer to REMOVAL [06/2016 - ] )