DTC P1C00: Battery Monitor Module Performance [06/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [06/2016 - ]

5. Turn the ignition switch off and wait at least 30 seconds.
6. Enter the following menus: Powertrain / Engine / DTC.
7. Read the DTCs.

   Refer to DTC CHECK / CLEAR [06/2016 - ]

   RESULT:
   
   

   Result	Proceed to
   DTC P1C00 is output	A
   No DTC is output	B

Result: 

OK 

REPLACE BATTERY STATE SENSOR ASSEMBLY. Refer to  REMOVAL [06/2016 - ] 

Result: 

NG 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [06/2016 - ]