Installation [06/2016 - ]: Procedure
- INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY
- Install a new gasket to the intake manifold.
- Connect the 2 water by-pass hoses to the throttle with motor body assembly with the 2 clamps.
- Install the throttle with motor body assembly to the intake manifold with the 4 bolts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
- Connect the throttle with motor body assembly connector.
- INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 4
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 3
- ADD ENGINE COOLANT
Refer to PROCEDURE - Step 2
- INSPECT FOR COOLANT LEAK
Refer to PROCEDURE - Step 1
- INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY NOTE:
Perform the following procedure after replacing the ECM, throttle with motor body assembly or any throttle with motor body assembly components.
- Turn the ignition switch to ON without operating the accelerator pedal.NOTE:
If the accelerator pedal is operated, perform the above steps again.
- Connect the Techstream to the DLC3 and clear the DTCs (Refer to GENERAL INFORMATION [06/2016 - ] ).
- Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.
Standard
Condition Engine Idle Speed A/C switched off 650 to 800 rpm NOTE:- Be sure to perform this step with all accessories off.
- Make sure that the shift lever is in neutral (for manual transmission).
- Make sure that the shift lever is in N or P (for automatic transmission).
- Enter the following menus: Data List / Throttle Sensor Volt%. Fully depress the accelerator pedal and check that the value is 80 to 90%.
- Perform a road test and confirm that there are no abnormalities.
- Turn the ignition switch to ON without operating the accelerator pedal.