DTC P0107: Manifold Absolute Pressure / Barometric Pressure Circuit Low Input; DTC P0108: Manifold Absolute Pressure / Barometric Pressure Circuit High Input [06/2016 - ]: Description

Manifold absolute pressure sensor uses a built-in sensor to detect the intake manifold pressure as a voltage. Additionally, because this measures the absolute pressure as the pressure within the intake manifold without detecting the atmospheric pressure as a standard value, this enables measurements without being influenced by changes in atmospheric pressure from altitude or other causes.

DTC No.	DTC Detection Condition	Trouble Area
P0107	Manifold absolute pressure sensor voltage is less than 0.61 V for 2 seconds or more. (1 trip detection logic)	Open or short in manifold absolute pressure sensor circuit Manifold absolute pressure sensor ECM
P0108	Manifold absolute pressure sensor voltage is 3.91 V or more for 2 seconds or more. (1 trip detection logic)

HINT:

When any of these DTCs are output, check the manifold absolute pressure using the Techstream. Enter the following menus: Powertrain / Engine / Data List / MAP.

Manifold Absolute Pressure (kPa [mmHg])	Malfunction
Approximately 0 [0]	Short in MAP circuit
141 [1058] or more	Short in VC circuit Open in PIM circuit Open in E1 circuit