| Monitor runs whenever the following DTCs are not stored |
None |
| All of the following conditions are met |
- |
| Throttle position voltage |
0.2 V or higher, and less than 2 V |
| Time after engine start |
5 seconds or more |
| Battery voltage |
10.5 V or higher |
| Engine coolant temperature |
70°C (158°F) or higher |
| Estimated load |
30% or higher, and less than 70% |
| Mass air flow meter sensor circuit fail (P0100, P0102, P0103, P010C, P010D) (Pending + MIL) |
Not detected |
| Intake air temperature sensor circuit fail (P00AC, P00AD, P0110, P0112, P0113) (Pending + MIL) |
Not detected |
| Engine coolant temperature sensor circuit fail (P0115, P0117, P0118) (Pending + MIL) |
Not detected |
| Crankshaft position sensor circuit fail (P0335, P0337, P0338) (Pending + MIL) |
Not detected |
| Throttle position sensor circuit fail (P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135) (Pending + MIL) |
Not detected |
| EVAP System Pressure Sensor circuit fail (P0450, P0452, P0453) (Pending + MIL) |
Not detected |
| Leak detection pump fail (P2401, P2402) (Pending + MIL) |
Not detected |
| Evap system vent valve fail (P2419, P2420) (Pending + MIL) |
Not detected |