Problem Symptoms Table [03/2017 - 08/2022]
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to the system before inspecting the suspected areas below.
- If the problem occurs in certain locations or times of day, the possibility of wave interference is high.
- If a malfunction occurred after optional components were installed by the dealer, check if there is wave interference from the components.
SMART KEY SYSTEM (FOR START FUNCTION)
| Symptom | Suspected Area | Link |
|---|---|---|
| Power source mode does not change to on (IG) or on (ACC) | Smart key system (for Entry Function) | Refer to Power Source Mode does not Change to ON (IG and ACC) [03/2017 - 06/2017] , or refer to Power Source Mode does not Change to ON (IG and ACC) [06/2017 - ] |
| Wireless charging system | ||
| Affected by wave interference | ||
| Transmitter battery | ||
| Electrical key transmitter sub-assembly | ||
| No. 1 indoor electrical key antenna assembly (front floor) | ||
| No. 1 indoor electrical key antenna assembly (rear floor) | ||
| Engine switch | ||
| Wire harness or connector | ||
| Instrument panel junction block assembly | ||
| Certification ECU (Smart key ECU assembly) | ||
| Power source mode does not change to on (IG) | Wire harness or connector | Refer to Power Source Mode does not Change to ON (IG) [03/2017 - ] |
| Relay | ||
| Instrument panel junction block assembly | ||
| Certification ECU (Smart key ECU assembly) | ||
| Power source mode does not change to on (ACC) | Wire harness or connector | Refer to Power Source Mode does not Change to ON (ACC) [03/2017 - ] |
| Relay | ||
| Instrument panel junction block assembly | ||
| Certification ECU (Smart key ECU assembly) | ||
| Engine does not start | Transmitter battery | Refer to Engine does not Start [03/2017 - 06/2017] , or refer to Engine does not Start [06/2017 - 03/2020] , or refer to Engine does not Start [03/2020 - 08/2021] , or refer to Engine does not Start [08/2021 - 08/2022] |
| Affected by wave interference | ||
| SFI system | ||
| Steering lock function | ||
| Immobiliser function | ||
| Wire harness or connector | ||
| ST fuse | ||
| ST NO. 1 relay | ||
| Park/neutral position switch assembly | ||
| Electrical key transmitter sub-assembly | ||
| Stop light switch assembly | ||
| Certification ECU (Smart key ECU assembly) | ||
| New key cannot be registered | LIN communication system | Refer to New Key cannot be Registered [03/2017 - 08/2022] |
| Meter / gauge system | ||
| Reregistration | ||
| Electrical key transmitter sub-assembly | ||
| Steering lock ECU (Steering lock actuator or upper bracket assembly) | ||
| Certification ECU (Smart key ECU assembly) | ||
| Additional key cannot be registered | Smart key system (for Start Function) | Refer to Additional Key cannot be Registered [03/2017 - 08/2022] |
| Steering lock function | ||
| Electrical key transmitter sub-assembly | ||
| Certification ECU (Smart key ECU assembly) | ||
| New key registration warning message is not displayed | Lighting system (int) | Refer to New Key Registration Warning Message is not Displayed [03/2017 - ] |
| Meter / gauge system | ||
| Certification ECU (Smart key ECU assembly) | ||
| Unable to unlock steering wheel (Engine cannot start) | Wire harness or connector | Refer to Unable to Unlock Steering Wheel (Engine cannot Start) [03/2017 - 08/2022] |
| Steering lock ECU (Steering lock actuator or upper bracket assembly) | ||
| Certification ECU (Smart key ECU assembly) | ||
| Steering lock does not lock | Lighting system (int) | Refer to Steering Lock does not Lock [03/2017 - 08/2022] |
| Wire harness or connector | ||
| Steering lock ECU (Steering lock actuator or upper bracket assembly) | ||
| Certification ECU (Smart key ECU assembly) | ||
| Security indicator light does not blink | Wire harness or connector | Refer to Security Indicator Light Does not Blink [03/2017 - ] |
| Security indicator light (Telltale light assembly) | ||
| Main body ECU (Multiplex network body ECU) | ||
| Certification ECU (Smart key ECU assembly) | ||
| Immobiliser system does not operate properly | Communication ID registration was defective | Refer to Immobiliser System does not Operate Properly [03/2017 - 06/2017] , or refer to Immobiliser System does not Operate Properly [06/2017 - 08/2022] |
| Wire harness or connector | ||
| ECM | ||
| Engine cannot be started by remote air conditioner with remote start (Both the wireless door lock control system and push-button start function operate normally)* | Refer to "Remote Engine Starter does not Operate" | Refer to Remote Engine Starter does not Operate [03/2017 - 09/2019] , or refer to Remote Engine Starter does not Operate [09/2019 - 08/2022] |
- *: for Toyota Entune Remote Connect Compatible Type