DTC B2313: Glass Position Initialization Incomplete [12/2013 - ]: Procedure

1. Turn the ignition switch to ON.
2. Initialize the power window regulator motor assembly.

   Refer to INITIALIZATION [12/2013 - ]

   HINT: 

   Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.

NEXT 

1. Turn the ignition switch off.
2. Wait for at least 10 seconds, and then turn the ignition switch to ON.
3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [12/2013 - ]

   Body Electrical > D-Door Motor > Trouble Codes 

   Body Electrical > P-Door Motor > Trouble Codes 

   HINT: 

   Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.

   OK

   DTC B2313 is not output.

   Result

   Result	Proceed to
   OK	A
   NG (Driver door power window)	B
   NG (Front passenger door power window)

Result:  1

A 

END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED) 

Result:  2

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR). Refer to  REMOVAL [12/2013 - ]