DTC C1AA0: Front Camera Module Circuit [11/2015 - 07/2020]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [11/2015 - 07/2020]

   Chassis > LKA/LDA > Clear DTCs 

2. Perform the following procedure.

   HINT: 

   If the following procedure is not performed, the previously output DTC cannot be detected.

   1. Turn the power switch on (IG) and wait 2 seconds or more.
3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [11/2015 - 07/2020]

   Chassis > LKA/LDA > Trouble Codes 

   Result

   Result	Proceed to
   DTC C1AA0 is not output	A
   DTC C1AA0 is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2015 - 12/2018]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2018 - 07/2020] 

Result: 

B 

See step  2

1. Replace the forward recognition camera.

   Refer to REMOVAL [11/2015 - 07/2020]

2. Perform Forward Recognition Camera Learning.

   Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [11/2015 - 07/2020]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END