DTC P0460-2A: Fuel Level Sensor "A" Signal Stuck In Range [11/2018 - 08/2020]: Procedure

1. Interview the customer for details about when they refuel the vehicle.

   HINT: 

   When the fuel tank is full, if the vehicle is repeatedly driven a short distance and then refueled, the fuel sender gauge output value will not change. In this case, the ECM may judge that the fuel sender gauge is stuck and store DTC P0460-2A. If the vehicle was driven in this manner, as the DTC was stored due to a user action, clear the DTCs without performing troubleshooting and return the vehicle to the customer.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Remove the fuel sender gauge assembly.

   Refer to REMOVAL [11/2018 - 08/2020]

2. Inspect the fuel sender gauge assembly.

   Refer to INSPECTION [11/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE FUEL SENDER GAUGE ASSEMBLY 

Refer to REMOVAL [11/2018 - 08/2020]

Result: 

OK 

See step  3

1. Remove the NO. 2 fuel sender gauge assembly.

   Refer to REMOVAL [11/2018 - 08/2020]

2. Inspect the NO. 2 fuel sender gauge assembly.

   Refer to INSPECTION [11/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

CHECK FOR INTERMITTENT PROBLEMS 

Refer to CHECK FOR INTERMITTENT PROBLEMS [11/2018 - 08/2020]

Result: 

NG 

REPLACE NO. 2 FUEL SENDER GAUGE ASSEMBLY 

Refer to REMOVAL [11/2018 - 08/2020]