DTC P0A14-12: Engine Mount "A" Control Circuit High Circuit Short to Battery [11/2018 - 08/2020]: Procedure

1. Inspect the vacuum switching valve (for active control engine mount system).

   Refer to INSPECTION [11/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE VACUUM SWITCHING VALVE (FOR ACTIVE CONTROL ENGINE MOUNT SYSTEM). Refer to  REMOVAL [11/2018 - ] 

Result: 

OK 

See step  2

1. Disconnect the vacuum switching valve (for active control engine mount system) connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C7-2 or C40-44 (ACM) - Other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [11/2018 - 08/2020] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR