Installation [11/2018 - 08/2020]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

• w/ Canister Pump Module:

  Refer to INITIALIZATION [11/2018 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020]

• w/o Canister Pump Module:

  Refer to INITIALIZATION [11/2018 - 08/2020]

1. Install the mass air flow meter sub-assembly with the 2 screws.
   NOTE:

   • If the mass air flow meter sub-assembly has been struck or dropped, replace it.
   • If reusing the mass air flow meter sub-assembly, be sure to inspect the O-ring.
   • Make sure that the O-ring is not cracked or moved out of place when installing the mass air flow meter sub-assembly.
2. Connect the mass air flow meter sub-assembly connector.