Caution / Notice / Hint
NOTE:
- Before replacing the engine stop and start ECU, read the number of starter operations and write it into a new engine stop and start ECU.
Refer to REGISTRATION [11/2018 - 10/2019] , or refer to REGISTRATION [10/2019 - 12/2021] , or refer to REGISTRATION [12/2021 - 10/2022]
- After replacing the engine stop and start ECU or air conditioning amplifier assembly, reset and perform learning of the air conditioning information in the engine stop and start ECU.
Refer to REGISTRATION [11/2018 - 10/2019] , or refer to REGISTRATION [10/2019 - 12/2021] , or refer to REGISTRATION [12/2021 - 10/2022]
- After replacing the engine stop and start ECU or airbag ECU assembly, clear and calibrate the deceleration sensor zero point in the engine stop and start ECU.
Refer to REGISTRATION [11/2018 - 10/2019] , or refer to REGISTRATION [10/2019 - 12/2021] , or refer to REGISTRATION [12/2021 - 10/2022]
- When the engine stop and start ECU or oil pump with solenoid assembly is replaced, check the oil pump with solenoid assembly.
Refer to REGISTRATION [11/2018 - 10/2019] , or refer to REGISTRATION [10/2019 - 12/2021] , or refer to REGISTRATION [12/2021 - 10/2022]
HINT:
- When stop and start priority control (Extended) is selected, the operation of the air conditioning system is limited. If the customer reports that the cooling effectiveness of the air conditioning system is poor, check the selected control mode. If stop and start priority control (Extended) is selected, cancel the control mode and check if the cooling effectiveness of the air conditioning system improves. If it improves, explain to the customer that the operation of the air conditioning system was limited by stop and start control.
- Depending on the vehicle conditions, the stop and start operation time may not change even if stop and start priority control (Extended) is selected.