Monitor Description

While the engine is being cranked, positive battery voltage is applied to terminal STA of the ECM. If the ECM detects the starter control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit. The ECM then illuminates the MIL and stores the DTC.

This monitor runs when the vehicle is driven at 20 km/h (12.43 mph) or more for 20 seconds or more.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory	Note
P0615-12	Starter Relay Circuit Short to Battery	All of the following conditions are met, and battery voltage of 10.5 V or higher is applied to the ECM for 20 seconds (1 trip detection logic): (a) The vehicle speed is 20 km/h (12.43 mph) or more. (b) The engine speed is 1000 rpm or higher. (c) The STA signal is on.	ST relay Park/neutral position switch assembly Starter relay (ST) circuit ECM	Comes on	DTC stored	SAE Code: P0617