DTC P0011-00: Camshaft Position "A" - Timing Over-Advanced or System Performance Bank 1 [02/2019 - 06/2020]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTC P0011-00 is output	A
   DTC P0011-00 and other DTCs are output	B

   HINT: 

   If any DTCs other than P0011-00 are output, troubleshoot those DTCs first.

Result: 

B 

GO TO DTC CHART 

Refer to DIAGNOSTIC TROUBLE CODE CHART [02/2019 - 10/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2019 - 06/2020]

Result: 

A 

See step  2

1. Replace the camshaft timing gear assembly.

   Refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 06/2020]

   HINT: 

   Perform "Inspection After Repair" after replacing the camshaft timing gear assembly.

   Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   HINT: 

   Clear the DTC without using the Techstream.

5. Turn the ignition switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
2. Enter the following menus: Powertrain / Engine / Trouble Codes.
3. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P0011-00 is output	B

Result: 

A 

END 

Result: 

B 

REPLACE ECM 

Refer to REMOVAL [02/2019 - 08/2020]