Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Vehicle Control History may be stored in the hybrid vehicle control ECU assembly if the engine is malfunctioning. Certain vehicle condition information is recorded when Vehicle Control History is stored. Reading the vehicle conditions recorded in both the freeze frame data and Vehicle Control History can be useful for troubleshooting.
for 2WD with NICKEL METAL HYDRIDE BATTERY
Refer to VEHICLE CONTROL HISTORY [11/2018 - 08/2020]
for AWD with NICKEL METAL HYDRIDE BATTERY
Refer to VEHICLE CONTROL HISTORY [02/2019 - ]
for LITHIUM-ION BATTERY
Refer to VEHICLE CONTROL HISTORY [06/2020 - ]
(Select Powertrain in Health Check and then check the time stamp data.)
- If any "Engine Malfunction" Vehicle Control History item has been stored in the hybrid vehicle control ECU assembly, make sure to clear it. However, as all Vehicle Control History items are cleared simultaneously, if any Vehicle Control History items other than "Engine Malfunction" are stored, make sure to perform any troubleshooting for them before clearing Vehicle Control History.
for 2WD with NICKEL METAL HYDRIDE BATTERY
Refer to VEHICLE CONTROL HISTORY [11/2018 - 08/2020]
for AWD with NICKEL METAL HYDRIDE BATTERY
Refer to VEHICLE CONTROL HISTORY [02/2019 - ]
for LITHIUM-ION BATTERY
Refer to VEHICLE CONTROL HISTORY [06/2020 - ]
HINT:
- The following conditions may also cause DTC P0505-00 to be stored:
- If the floor carpet or floor mat is resting slightly on the accelerator pedal, causing the accelerator pedal to be slightly depressed and therefore the throttle valve position to be slightly open.
- The accelerator pedal is not fully released.
- Refer to "Data List / Active Test" [Engine Speed, Engine Speed and ISC Learning Value].
- Read Freeze Frame Data using the Techstream. The ECM records vehicle and driving condition information as Freeze Frame Data the moment a DTC is stored. When troubleshooting, Freeze Frame Data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.