LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2019 >> RAV4 LE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 137 (Engine Control System (A25A-FXS) (W/ Canister Pump Module) - Diagnostic Codes (12 Of 13)) >> SFI SYSTEM (w/ Canister Pump Module) >> DTC P3190-00: Poor Engine Power; DTC P3191-00: Engine does not Start [02/2019 - 06/2020] >> Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P3190-00: Poor Engine Power; DTC P3191-00: Engine does not Start [02/2019 - 06/2020]: Description

WARNING: This page is about a different variant/trim than selected.

The ECM receives signals from the hybrid vehicle control ECU assembly such as the requested engine torque, target engine speed and engine cranking status, and controls the engine output based on the target engine speed and requested torque.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P3190-00 Poor Engine Power When all of the following conditions are met (1 trip detection logic):
  • The engine speed is 650 rpm or more (varies depending on the engine coolant temperature).
  • Engine torque requested by the hybrid vehicle control ECU exceeds a certain value.
  • The hybrid vehicle control ECU assembly judges that the engine has started.
  • The fuel tank is not empty.
  • Communication between the hybrid vehicle control ECU assembly and ECM is normal.
  • The actual engine torque is less than 20% of the requested engine torque for 6 seconds, or until the crankshaft rotates 100 times (whichever takes longer, differs depending on the engine coolant temperature).
  • Intake system
  • Throttle with motor body assembly
  • Fuel system
  • Engine assembly
  • Mass air flow meter sub-assembly
  • Out of fuel
  • Engine coolant temperature sensor
  • Crankshaft position sensor
  • Camshaft position sensor
  • EGR valve assembly
  • Fuel pump control circuit
  • PCV valve and hose
  • PCV hose connections
  • ECM
Comes on DTC stored SAE Code: P3190
P3191-00 Engine does not Start When all of the following conditions are met (1 trip detection logic):
  • The engine speed is 650 rpm or more (varies depending on the engine coolant temperature).
  • The fuel tank is not empty.
  • Communication between the hybrid vehicle control ECU assembly and ECM is normal.
  • After the hybrid vehicle control ECU assembly sends the engine start request signal, it does not detect engine start (generation of engine torque) for 6 seconds, or until the crankshaft rotates 100 times (whichever takes longer, differs depending on the engine coolant temperature).
  • Intake system
  • Throttle with motor body assembly
  • Fuel system
  • Engine assembly
  • Mass air flow meter sub-assembly
  • Out of fuel
  • Engine coolant temperature sensor
  • Crankshaft position sensor
  • Camshaft position sensor
  • EGR valve assembly
  • Fuel pump control circuit
  • PCV valve and hose
  • PCV hose connections
  • ECM
Comes on DTC stored SAE Code: P3191