DTC P0630-51: VIN Not Programmed [11/2018 - 08/2020]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630-51)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
NOTE:If P0630-51 is output, the VIN or frame number must be written to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when the VIN or frame number is written. If DTCs other than P0630-51 are output, troubleshoot them first.
Result
Result Proceed to DTC P0630-51 is output A DTC P0630-51 and other DTCs are output B
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2018 - 08/2020]
Result:
A
See step 2
- WRITE VIN OR FRAME NUMBER
- Write the VIN or frame number.
Refer to REGISTRATION [11/2018 - 08/2020]
Result
Proceed to NEXT
Result:
NEXT
END
- Write the VIN or frame number.