Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
CASE 1
| Monitor runs whenever the following DTCs are not stored | None |
| Both of the following conditions are met | - |
| Starter | After off to on timing |
| Minimum auxiliary battery voltage while starter on | Less than 11 V |
CASE 2
| All of the following conditions are met | - |
| Engine speed | 600 rpm or higher |
| Exhaust camshaft position sensor range check fail (P0367, P0368) | Not detected |
| Ignition switch | On |
| Auxiliary battery voltage | 8 V or higher |
| Exhaust camshaft position sensor voltage | 0.3 to 4.7 V |
| Hybrid control module judge | Engine running |
| Lost communication with hybrid vehicle control ECU assembly (U0293) | Not detected |